Arduino is an open source hardware and software company and maker community. Arduino started in the early 2000s. Popular with electronic makers, Arduino offers a lot of flexibility through an open source system.
Button support has been added recently, but most motherboards don't have many pins free. Multiplexing will allow more buttons to be operated.
No response
In the button configuration, I would like to be able to set the pins that support the
Hardware
Esp32
Hardware: ESP32 Devkit
onAPClientConnectCallback for ESP32
WiFimanager Branch/Release: Master
Esp32:
Need of onAPClientConnectCallback
Module: ESP32 DevKit
Would it be possible to have an onAPClientConnectCallback in blocking mode to show message on oled display?
Blynk library version: master branch at 144a90f3bdb66c3b6c03cce0335c1f1e304d91d6
IDE: VS Code + PlatformIO
IDE version: 1.52.1
Board type: ESP8266
Additional modules: Arduino ESP8266
Blynk.run() blocks if there is no internet connection on the network and connecting to a local server via SSL.
According to my investigation, `BlynkArduinoClientSecure::conn
Created by Massimo Banzi
Released 2003
The uncompensated temperature of the BMP180 is incorrectly converted to a 16-bit signed value, instead of a 32-bit signed value (long). Since the data is 16-bits wide and can therefore not be negative, the easy fix would be to do the following:
sip.js(1128): uncompensated = uint16(data[0], data[1]);
Please see page 15 of the manual of the BMP180 chip:
https://ae-bst.resource.bosch.com/media